topic Re: WCS 4.0 - RRM Thresholds in Wireless

WCS 4.0 - RRM Thresholds

jmagnusson — Sat, 03 Jul 2021 20:30:09 GMT

I have alot of interference thresholds beening set off with the default 10%. I have a dense deployment and I am sure it is co channel interference. Does anyone have a recommendation what this threshold should be set at to point out "real" world issues ?

Re: WCS 4.0 - RRM Thresholds

b.speltz — Wed, 24 Jan 2007 15:26:07 GMT

Unwanted RF signals in the same frequency band that can lead to a degradation or loss of service is interference. These signals can either be from 802.11 or non-802.11 sources. Refer URL

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008072c759.shtml#key_terms

Re: WCS 4.0 - RRM Thresholds

d.beaver — Wed, 24 Jan 2007 15:56:36 GMT

imagnusson,

I agree. I also have a dense population of access points and am getting some interference alarms due to the default settings. Since the last response only gave us a definition of "interference", maybe someone can tell us what they have done to change the thresholds to control alarms.

Re: WCS 4.0 - RRM Thresholds

Dmitry Halavin — Wed, 07 Feb 2007 18:34:14 GMT

Interference - from other 802.11 devices

Noise - from non-802.11 devices operating in the same frequency as the APs.

The thresholds for each can be configured via Configure --> Templates (or controller) --> 802.11a or b/g --> RRM Thresholds