topic Cisco CAP3602i fail to change Lightweight AP to be Autonomous AP in Wireless

Cisco CAP3602i fail to change Lightweight AP to be Autonomous AP

jacob.mmchan — Sat, 27 May 2023 12:36:21 GMT

AP#debug capwap console cli

AP(config)#interface BVI1

AP(config-if)#ip add 172.30.30.2 255.255.255.0

AP#archive download-sw /force-reload /overwrite tftp://10.0.5.137/ap3g2-k9w7-tar.153-3.JF15.default

-----

Premature end of tar file
ERROR: Problem extracting files from archive.
Download image failed, notify controller!!! From:8.0.121.0 to 8.5.182.0, FailureCode:3

archive download: takes 178 seconds

Re: Cisco CAP3602i fail to change Lightweight AP to be Autonomous AP

Flavio Miranda — Sat, 27 May 2023 13:37:43 GMT

8.0 to 8.5 is a huge change. Try upgrade to somthing around 8.3 first.

Re: Cisco CAP3602i fail to change Lightweight AP to be Autonomous AP

Leo Laohoo — Sun, 28 May 2023 02:44:40 GMT

That is the wrong file. The filename should have an extension of TAR and not "default".

But first, you need to clean out the flash by using this command: delete /f /r flash:.

If you have the TAR file, use this command instead: archive tar /x tftp://<IP ADDRESS>/filename.tar flash:

Re: Cisco CAP3602i fail to change Lightweight AP to be Autonomous AP

Rich R — Sun, 28 May 2023 13:42:59 GMT

This is the correct file:
https://software.cisco.com/download/home/284006700/type/284180979/release/15.3.3-JF15