topic Re: Mobility Express Issues after Upgrade in Wireless

Mobility Express Issues after Upgrade

AhmadZ — Wed, 14 Jun 2023 16:32:36 GMT

Dear All,

I've upgraded my Cisco AP1815i (from version 8.5.182 to 8.10.183) which is a mobility express and capwap at the same time. After upgrade, capwap remains unchanged while no access to mobility express, it seems like the IP of the mobility express has changed also.

I checked that the AP Image type is mobility express, but how can I change the mobility express IP? I couldn't find any command for such while logged in as SSH,

Thanks!

Re: Mobility Express Issues after Upgrade

Denniz — Thu, 15 Jun 2023 06:50:30 GMT

Use a console cable (or ssh into it with the current ip) and use the commands;

en
capwap ap ip [ip-address] [netmask] [default router]

Re: Mobility Express Issues after Upgrade

AhmadZ — Thu, 15 Jun 2023 12:45:19 GMT

This changes the IP of the capwap, not the mobility express

Re: Mobility Express Issues after Upgrade

Mark Elsen — Thu, 15 Jun 2023 13:27:44 GMT

- IP address should not change with upgrades , perhaps someone forgot to save the config , perhaps it is advisable to reset the AP and configure the mobility express setup again (including IP)

Re: Mobility Express Issues after Upgrade

Rich R — Thu, 15 Jun 2023 14:09:56 GMT

If it's the same as AireOS WLC (ME is based on that) then try:
config interface address management <IP> <mask> <gateway>

Re: Mobility Express Issues after Upgrade

Denniz — Wed, 21 Jun 2023 09:34:51 GMT

You are right, I misread the question, thanks for pointing that out!