topic Migrating an AP from one WLC to another using Cisco Prime in Wireless

Migrating an AP from one WLC to another using Cisco Prime

rickysahni — Thu, 23 Nov 2023 13:34:05 GMT

Hi Guys.. a simple one... I need to bulk migrate different APs (3700s, 2600s, 3800s, 2700s) from one 5520 WLC to another (physically relocating each one in turn to a new DC).

I am looking to use a template on Cisco Prime to do this and amending the Primary controller name and secondary controller name in Controllers configuration, highlighting the target APs and then deploying.

Question is - do i need to select 'reboot AP' as part of the process. Do the APs need to be rebooted after for the migration to take effect?

anything else i need to consider?

Re: Migrating an AP from one WLC to another using Cisco Prime

Haydn Andrews — Thu, 23 Nov 2023 22:15:15 GMT

Depends on the speed you need them to fail over. I generally use it so I dont have to wait for them to fail over.

Re: Migrating an AP from one WLC to another using Cisco Prime

balaji.bandi — Thu, 23 Nov 2023 23:25:18 GMT

You can use PI for Bulk move :

Prime - Create a template Configuration > Templates > Lightweight Access Points. Configure primary and secondary controllers under AP Parameters and then deploy to all access points.

Follow below thread for screenshot :

https://community.cisco.com/t5/wireless/move-bulk-accesspoints-to-an-other-controller/td-p/3936323

Question is - do i need to select 'reboot AP' as part of the process. Do the APs need to be rebooted after for the migration to take effect?

YES will reboot to join the new WLC.

Re: Migrating an AP from one WLC to another using Cisco Prime

rickysahni — Fri, 24 Nov 2023 09:45:17 GMT

Great - will they reboot themselves automatically or do i need to select reboot AP within the template?

Re: Migrating an AP from one WLC to another using Cisco Prime

balaji.bandi — Fri, 24 Nov 2023 17:14:40 GMT

When go to menu

Config ---> templates-->Lioghtweight AP --> create template

template name - AP Move

AP Parameter

Check box reboot AP

Check box controller config

add new WLC

save and apply to AP groups