topic Re: CW9166I Access Point CLI Commands in Wireless

CLI Command for CW9166 Access Point

madhurimuppalla — Wed, 01 Nov 2023 05:16:02 GMT

Hi,

Is there any CLI command in CW9166 AP to enable, disable and read the sensor data such as temperature, humidity,

air-quality from the built-in sensors?

Re: CLI Command for CW9166 Access Point

Leo Laohoo — Thu, 09 Oct 2025 03:28:58 GMT

@madhurimuppalla wrote:
read the sensor data such as temperature, humidity,air-quality from the built-in sensors?

From the WLC:

test platform software database get ewlc_oper/ap_temp;ap_mac=aaaabbbbcccc

test platform software database get ewlc_oper/ap_air_quality;ap_mac=aaaabbbbcccc

NOTE:

1. The sensors can only work when DNA Spaces have "seen" the APs. Without DNA Spaces, the sensors will be disabled.
2. The two commands are present in 17.9.X & 17.12.1 but they are absent in 17.6.4.

From the AP, try:

sh thermal-control-summary

NOTE:

1. This command should be available without DNA Spaces.

2. Take note of CSCwh60483 & CSCwk74648.

CW9166I Access Point CLI Commands

madhurimuppalla — Thu, 23 Nov 2023 16:04:04 GMT

Hi,

Is there any CLI commands in CW9166 AP to check the status of Monitor Radio, BLE, AP power consumption details and also sensor data like humidity, air-quality from build-in sensors?

Re: CW9166I Access Point CLI Commands

balaji.bandi — Thu, 23 Nov 2023 16:15:12 GMT

Most of the information can get from Parent WLC what you looking if the AP register with WLC.

you can refer below thread :

https://community.cisco.com/t5/wireless/cli-command-for-cw9166-access-point/td-p/4951803

Re: CW9166I Access Point CLI Commands

Leo Laohoo — Thu, 23 Nov 2023 22:03:43 GMT

Has the 9166 been added to DNA Spaces yet?