topic Re: Cisco AP in Wireless

Cisco AP

Lekshman Narayanan — Sun, 03 Dec 2023 07:58:42 GMT

Hi friends, i have cisco WLC CT5760- all the AP's joined with WLC but when the clients tried to connect " unable to join or network unavailable " in mobiles and cannot connect to this network- in Laptops. DHCP pool looking good and WLC also accessible.

Any support..

Re: Cisco AP

Mark Elsen — Sun, 03 Dec 2023 08:29:46 GMT

- Note that the converged access wireless solutions are depreciated and EOL , and no longer advised for production use , consider switching to the 9800 based platforms, you can for instance start with virtual 9800 which is can be downloaded without a service contract ,

Re: Cisco AP

Mark Elsen — Sun, 03 Dec 2023 08:38:19 GMT

- Adding : if proceeding ; checkout https://www.yumpu.com/en/document/view/36850615/brkewn-3021

Re: Cisco AP

balaji.bandi — Sun, 03 Dec 2023 08:38:48 GMT

i have cisco WLC CT5760- all the AP's joined with WLC

what AitOS running ? what AP Models,. is this new setup ? or only some clients not working ?

unable to join or network unavailable

this caused many reasons ? as you mentioned none was able to connect, this could be authentication issue may be.

what kind of authentication you using ?

Follow below guide to troubleshoot the issue using client MAC address :

https://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/100260-wlc-debug-client.html

Re: Cisco AP

Rich R — Sun, 03 Dec 2023 22:59:52 GMT

1. The platform is end of support - Cisco abandoned the converged wireless platforms because they were a disaster and are replaced by 9800 series WLCs as Marce pointed out.
https://www.cisco.com/c/en/us/support/wireless/5760-wireless-lan-controller/model.html
2. Very few people have used those converged wireless (early IOS-XE WLC) platforms so there is little to no experience with them to share with you and Cisco TAC will not support them.
3. Make sure you're using the last available version of software (already more than 4 years old):
https://software.cisco.com/download/home/284397235/type/282046477/release/3.6.10E
4. Was it working before? What changed?

Re: Cisco AP

Anjana A — Mon, 04 Dec 2023 03:49:48 GMT

Hi,

There are many reasons which could cause this

1. while trying to connect users are bale to view the ssid?

2. what is the Ap mode?in case of local mode the WLAN interfaces are mapped correctly / in case of flexconnect vlan mapping or flex group mapping are in place.

3. Please collect the user mac address and check the policy manager state in the client.

Regards,

Anjana.

***** if u find it useful rate a star****