topic Re: "Failed to set P2PBlockingMode"...? in Wireless

"Failed to set P2PBlockingMode"...?

craighowson — Wed, 03 Jan 2024 15:10:17 GMT

I am trying to configure P2P Blocking Action to "drop" on our guest network but when trying to configure this it throws the following error (see below).

Any suggestions?

TIA

Re: "Failed to set P2PBlockingMode"...?

Mark Elsen — Wed, 03 Jan 2024 15:41:51 GMT

- Please include controller & type/model + software version (?)

Re: "Failed to set P2PBlockingMode"...?

craighowson — Thu, 04 Jan 2024 10:48:09 GMT

We are using 2x 5520 WLC's and running OS 8.10.183.0

Thanks

Re: "Failed to set P2PBlockingMode"...?

MHM Cisco World — Thu, 04 Jan 2024 10:58:08 GMT

There is limitations of using p2p block and wlc HA.

MHM

Re: "Failed to set P2PBlockingMode"...?

craighowson — Thu, 04 Jan 2024 11:13:14 GMT

Ah, that might be the issue then.

Do you know where I might find information on this please? I have found the restrictions info in the 8.10.183.0 config guide but it doesn't mention anything about HA.

Re: "Failed to set P2PBlockingMode"...?

Mark Elsen — Thu, 04 Jan 2024 11:25:39 GMT

- Take care of these restrictions : https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01001011.pdf

Re: "Failed to set P2PBlockingMode"...?

craighowson — Thu, 04 Jan 2024 15:14:46 GMT

Thanks Marce1000, appreciate the info.

I have had a read of that document and the restrictions only seem to apply to Flexconnect AP's, which we are not using. All our AP's centrally switch and are configured in local mode.

I cannot seem to see anything that points towards the issue we are experiencing... unless I am missing something?