topic Re: Power issues 9115AXi in Wireless

Power issues 9115AXi

MedTiti92 — Wed, 10 Jan 2024 10:34:12 GMT

i have Cisco 9115 axi AP, when i plug in my switch POE, it doesn't turn on in my switch(like the port is down, but it doesn't), but in the side of my AP, i see alternate red and green ligth.

See below the initial boot messages error

Re: Power issues 9115AXi

Mark Elsen — Wed, 10 Jan 2024 13:33:39 GMT

>...i see alternate red and green ligth.
- That means that the AP is not getting enough power (indeed) ; make sure that switch model can provide sufficient power for these AP models and also enable LLDP on the AP connected ports ,

Re: Power issues 9115AXi

Haydn Andrews — Wed, 10 Jan 2024 21:13:02 GMT

What @Mark Elsen said the switch is not providing enough power, or potentially needs LLDP/ CDP enabled

Re: Power issues 9115AXi

MedTiti92 — Sun, 14 Jan 2024 10:24:51 GMT

Hello guys,

sorry to answer late, i enable both cdp and lldp in the switch, but it is still same. before i used C1000 switch, now i changed the witch with C9200L, but same issues

Re: Power issues 9115AXi

Mark Elsen — Sun, 14 Jan 2024 10:55:13 GMT

- Try to use lldp only ,

Re: Power issues 9115AXi

balaji.bandi — Sun, 14 Jan 2024 12:11:26 GMT

now i changed the witch with C9200L

what is the full model of the switch and what IOS XE running on it

can you post below output from Cisco Switch

show version

show power inline

show run interface gigx/x (where the AP connected ?)

You can also use below Guide to troubleshoot Power issue :

https://www.cisco.com/c/en/us/support/docs/switches/catalyst-9200-series-switches/215636-troubleshooting-power-over-ethernet-poe.html

AP Power requirement :

LED Status :

it doesn't turn on in my switch(like the port is down, but it doesn't)

Did you connect PC and see are you able to get IP address and Port working as expected ?

Since both are Cisco product and Cisco AP CDP is good enough in this case.

Other Option if PoE is ok, try AP to reset to Factory and post again complete boot logs.