topic Re: Cisco 9136 LACP not working in Wireless

Cisco 9136 LACP not working

ANKUSH_SINGLA — Wed, 17 Jan 2024 17:49:54 GMT

Hello All,

I am suing C9800-L-F-K9 with 17.9.3 image and trying to use both ports for C9136I Wap.
WAP is connected to C9300-24UX model with image 17.9.3

Issues

Switch is configure with LACP Config and LAG is enabled on AP join profile in WLC
I am seeing below error on switch

%ETC-5-L3DONTBNDL2: Tex/x/x suspended: LACP currently not enabled on the remote port.

your inputs will be helpful, pls help

MHM Cisco World — Wed, 17 Jan 2024 17:53:00 GMT

Can i see the page you config LAG ?

Did you use lacp in wlc ? Or run mode ON?

MHM

Mark Elsen — Wed, 17 Jan 2024 18:00:17 GMT

- Set LACP mode on , for the AP intended LACP ports ,

ANKUSH_SINGLA — Wed, 17 Jan 2024 18:03:08 GMT

we enabled LAG on AP Join Profile not globally . in WLC i do not see any option for Mode on

MHM Cisco World — Wed, 17 Jan 2024 18:05:25 GMT

So the WLC not support lacp

You need to make port channel in switch use mode ON

MHM

Mark Elsen — Wed, 17 Jan 2024 18:08:46 GMT

>...in WLC i do not see any option for Mode on
- It's to be set on the switch , as in (e.g.) :

switch# configure terminal
switch(config)# interface fastethernet 0/1
switch(config-if)# channel-group 5 mode on

Change interface name and channel group number accordingly and verify settings with :

show ethernet channel summary

ANKUSH_SINGLA — Wed, 17 Jan 2024 18:11:04 GMT

@Mark Elsen @MHM Cisco World thanks for reply , does this mean WiFi6E waps will only work on Mode on not active ?

MHM Cisco World — Wed, 17 Jan 2024 18:16:00 GMT

I think Yes'

If you not see lacp option in general (and also check it in management tab) then Yes it support only ON mode.

MHM

Mark Elsen — Wed, 17 Jan 2024 19:05:43 GMT

- Indeed ,

M.