topic LAP cannot john vWLC in Wireless

LAP cannot john vWLC

adam shang — Thu, 08 Feb 2024 19:37:12 GMT

Just received a replacement LAP from Cisco, connected it to my eve environment which has vWLC inside to check. found this new LAP cannot john to vWLC. system version on both side are 8.10.130.0

From the prompt, can see the LAP get the ip addr and know the WLC, and send out the capwap request.

Any solution?

Re: LAP cannot john vWLC

jagan.chowdam — Thu, 08 Feb 2024 21:58:55 GMT

If you have access, can you console into the AP, reboot, log the boot sequence and share the complete log files.

What is the AP model?

Jagan Chowdam

Re: LAP cannot john vWLC

Leo Laohoo — Thu, 08 Feb 2024 22:00:00 GMT

What is the model of the AP?

What is the Date of Manufacture of the AP?

Re: LAP cannot john vWLC

adam shang — Thu, 08 Feb 2024 22:16:48 GMT

This AP I just received from Cisco to replace a broken one which is under the smartnet warranty. I use this AP connect to my laptop via the nic bridge to my vWLC in eve-ng. The version of my vWLC is 8.10.130.0(I download this version to keep it is the same as the version of LAP), the date of manufacture is 02/2023, the model is AP-AIR1562D-A-K9

Re: LAP cannot john vWLC

adam shang — Thu, 08 Feb 2024 22:32:47 GMT

sorry about that, I just forgot activate the licenses in vWLC. Now it is ok.

Re: LAP cannot john vWLC

Rich R — Sun, 11 Feb 2024 23:41:42 GMT

Of course 8.10.130.0 is rather old now - highly recommend to update as per TAC recommended link below.