topic Re: Wireless Controller in Wireless

Wireless Controller

richprime890 — Thu, 21 Mar 2024 09:15:20 GMT

Hi all, new here, am deploying a wireless network using the Cisco WLC series 9800 and APs, APs have successfully joined the controller but the SSIDs i created are not been broadcasted from the APs. Have anyone face this challenge before kindly advise.

Re: Wireless Controller

balaji.bandi — Thu, 21 Mar 2024 09:29:53 GMT

what is the IOS XE code running on the device - upgrade to latest 17.9.4a for stability, what model of AP

based on experience below need to check :

Ensure your AP get sufficient PoE power
NTP
Verify that Country on WLC code matches with the AP model number.
802.11b/g/n and 802.11 a/n/ac are enabled under wireless.
Check AP Profiles.
SSID is in enabled state.
SSID is being broadcasted.

Re: Wireless Controller

Mark Elsen — Thu, 21 Mar 2024 09:39:33 GMT

- Have a checkup of your 9800 WLC configuration with the CLI command show tech wireless and feed the output to : Wireless Config Analyzer

Re: Wireless Controller

Mark Elsen — Thu, 21 Mar 2024 09:41:21 GMT

- Added reply : also use the CLI command wireless config validate

Re: Wireless Controller

j.reichert — Thu, 04 Apr 2024 19:48:13 GMT

Make sure your SSID's are added to the policy tag you are using for these APs. Are you using more than one policy tag or just the default?

Re: Wireless Controller

j.reichert — Thu, 04 Apr 2024 20:11:23 GMT