topic Re: NCS associated with controller problem. in Wireless

NCS associated with controller problem.

Ahmed Ayaad — Mon, 05 Jul 2021 06:52:47 GMT

Dears,

I have PI 1.3 deployed on ESXI 4 (in HP Blade) with ip 192.168.220.230 after that i deployed virtual controller on the same blade with ip 192.168.220.232 the HP Blade connected to multilayer switch and i can ping from the NCS to Controller but when i try to add the controller on NCS i see the following error"Add Device Failed! Device already exists in the current domain"), how i can solve this problem,

Knowing that i configure on the controller the Community Name, IP address 192.168.220.230, Ip mask 192.168.220.232 ,Access mode ReadWrite, and status enabled.

Also configured Interface vlan(192.168.220.1) and the Blade access this vlan.

Thanks,

Re: NCS associated with controller problem.

Scott Fella — Tue, 31 Dec 2013 14:18:02 GMT

Might want to look at this link.

https://supportforums.cisco.com/docs/DOC-27761

Sent from Cisco Technical Support iPhone App

NCS associated with controller problem.

Sandeep Choudhary — Wed, 01 Jan 2014 11:57:21 GMT

adding to scott...

Check under Configure - Unknown Devices

Regards