topic Re: Cisco c9120axi-e webui problem in Wireless

Cisco c9120axi-e webui problem

m-ch — Fri, 12 Apr 2024 22:12:19 GMT

Hello,

I have a Cisco c9120axi-e access point, and I want to configure it, but the SSID is not displaying. I connected it with a router, it got an IP address, but the web interface of the access point is not accessible with its IP address.

Best regards,

Re: Cisco c9120axi-e webui problem

Mark Elsen — Sat, 13 Apr 2024 06:19:42 GMT

- It can only be used in standalone mode if it is running embedded wireless controller software (=?)

Re: Cisco c9120axi-e webui problem

balaji.bandi — Sat, 13 Apr 2024 08:43:26 GMT

it got an IP address - what IP it has ? from what device you try to connect to AP ?

check EWC deployment guide :

https://www.cisco.com/c/en/us/products/collateral/wireless/embedded-wireless-controller-catalyst-access-points/white-paper-c11-743398.html

Re: Cisco c9120axi-e webui problem

m-ch — Sat, 13 Apr 2024 13:38:06 GMT

I recently installed a network access point in my home network to extend my Wi-Fi coverage. I connected this access point to my main router, which also provides an internet connection, and I connected my PC to the same router.

While performing a scan of IP addresses on the network, I found that the access point had obtained the IP address 192.168.1.135. However, when I try to access this address via a web browser, I don't receive any response

Re: Cisco c9120axi-e webui problem

liviu.gheorghe — Sat, 13 Apr 2024 15:40:51 GMT

Try using https://192.168.1.135

Re: Cisco c9120axi-e webui problem

Mark Elsen — Sat, 13 Apr 2024 16:14:18 GMT

- GUI is only available if it is running embedded wireless controller software (=?)

Re: Cisco c9120axi-e webui problem

Ambuj M — Sat, 13 Apr 2024 18:34:31 GMT

If you are already running embedded wireless controller software, are you able to ping the AP IP or access it via terminal, if yes try different browser, try incognito mode.

Re: Cisco c9120axi-e webui problem

balaji.bandi — Sat, 13 Apr 2024 21:02:46 GMT

I don't receive any response

connect the console cable and check, also make sure you are running EWC image.

if all good you can start zero day provisioning as mentioned before post :

Day 0 – provisioning using the over-the-air setup wizard