topic Cisco Access Point 9130AXE CLI unusual Language in Wireless

Cisco Access Point 9130AXE CLI unusual Language

Rahul Kapadia — Sun, 20 Oct 2024 02:53:40 GMT

I've reset Cisco AP 9130AXE which was in EWC mode and now CLI shows some unusual languages.

j▒ĥk9▒9')▒▒9▒▒▒1/▒▒▒((I▒!q▒99▒H!▒7 H▒01w((I▒▒!▒1▒▒▒91▒91▒ ܖ▒H((Z((▒▒▒1▒H9▒▒▒1▒▒19▒ň1▒▒7▒▒79▒▒79▒▒H▒yI▒!)▒▒▒1▒)ͥy▒H▒▒▒!q9▒!9{穵9!!▒▒11▒(▒▒)▒▒▒9▒▒▒▒▒▒▒▒▒▒▒!▒▒!{q!!▒

Is there any other solution to reset it and solve this language issue?

Re: Cisco Access Point 9130AXE CLI unusual Language

Kasun Bandara — Sun, 20 Oct 2024 02:58:21 GMT

@Rahul Kapadia hi, is this from SSH or console? if its Console try correct baud rate 9600. also if you using usb console converter, make sure your drivers are properly installed in PC or try another converter.

Re: Cisco Access Point 9130AXE CLI unusual Language

Leo Laohoo — Sun, 20 Oct 2024 03:25:36 GMT

If the AP is on 17.12.X (and later), set the baud rate to 115200.

Re: Cisco Access Point 9130AXE CLI unusual Language

Rahul Kapadia — Sun, 20 Oct 2024 03:48:54 GMT

Kasun,

I am using console and baud is already set to 9600. There is no USB converted console.

Re: Cisco Access Point 9130AXE CLI unusual Language

Rahul Kapadia — Sun, 20 Oct 2024 03:50:10 GMT

Leo,

Thanks, 115200 worked.

Re: Cisco Access Point 9130AXE CLI unusual Language

Rich R — Sun, 20 Oct 2024 11:19:16 GMT

FYI: this change was introduced by https://bst.cisco.com/bugsearch/bug/CSCwe88390

This is documented in https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/technical-reference/c9800-best-practices.html#AccessPointConsoleBaudRate so it's a good idea to go through that Best Practices guide.