topic 9130-ap requirement in Wireless

9130-ap requirement

Anjana A — Thu, 24 Oct 2024 05:25:09 GMT

Hello Team,

Team is there an requirement for 9130 ap's should be connected on ten gigabit ethernet .

Regards,

Anjana

Re: 9130-ap requirement

Mark Elsen — Thu, 24 Oct 2024 05:52:53 GMT

- Ref : https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9100ax-access-points/nb-06-cat-9130-ser-ap-ds-cte-en.html
>...

Multigigabit Ethernet support

Multigigabit Ethernet provides uplink speeds of 5 Gbps and 2.5 Gbps, in addition to 100 Mbps and 1 Gbps. All speeds are supported on Category 5e cabling, as well as 10GBASE-T (IEEE 802.3bz) cabling.

Re: 9130-ap requirement

Anjana A — Thu, 24 Oct 2024 06:47:27 GMT

need some clarity:

if the number of connected users increses than normal will it cause user disconnection if the ap is connected in gigabit ethernet port?

We are encountering the error like client PMKID mismacth.

is it related to the interface utilization also FT is enabled in wlan

Regards,

Anjana

Re: 9130-ap requirement

Mark Elsen — Thu, 24 Oct 2024 07:10:28 GMT

- I don't think PMKID mismatch is related to AP usage and load ; more likely bug(s)
Include controller model and software version being used ,

Re: 9130-ap requirement

Anjana A — Thu, 24 Oct 2024 08:36:53 GMT

controller 9800-L:

AP:9130-Flex mode

WLC:17.9.5

Regards,

Anjana

Re: 9130-ap requirement

Mark Elsen — Thu, 24 Oct 2024 08:52:34 GMT

- There are a number of bugs which could be related in https://bst.cloudapps.cisco.com/bugsearch?pf=prdNm&prdNam=Cisco%20Catalyst%209800%20Series%20Wireless%20Controllers&kw=PMKID&bt=custV&sb=anfr

Therefore and since 17.9.x is EOL I would advise to upgrade 17.12.4 ,