topic Refresh your WAP561firmware in Wireless

WAP561 Scheduler to enable radios only during office time

bcag2_touticphoto — Mon, 05 Jul 2021 09:31:05 GMT

Hello,

I installed a WAP561 at my office, the two radios are activate and I defined 3 VAP, 2 "public" for visitors and one private for employes

I defined Scheduler : enable, Status Enabled/Reason:IsActive,

I defined a profil Weekday from 8am to 7:30pm

In Scheduler Association, I defined :

for radio 1:

WLAN 0, my profile is selected, interface Enabled

VAP0 (my first visitors VAP), profile name is at None and I can't change it!!, interface Enabled

VAP1 (my private), profile is selected, interface Enabled

all other VAP is None, Disabled

for radio 2:

WLAN 1, my profile is selected, interface Enabled

VAP0 (my second visitors VAP), profile name is at None and I can't change it!!, interface Enabled

all other VAP is None, Disabled

In log, my radio seems always running, in the evenning and during week-end.

Could you explain me what is wrong?

Thanks

Bertrand

I made a test this morning

bcag2_touticphoto — Tue, 17 Feb 2015 13:10:50 GMT

I made a test this morning and It works. I add a profil test that stop in the morning, and my computer lost the connexion.

As I turn "off" radios, it is ok but what I don't undestand is if I only want to schedule vap0, is it possible... why I can't change wlan0:vap0 and wlan1:vap0 ?

Thanks

Bertrand

check once if it helpshttps:/

Saurav Lodh — Wed, 18 Feb 2015 10:07:41 GMT

check once if it helps

https://supportforums.cisco.com/discussion/12082216/wap561-keeps-becoming-unresponsive

Find the attached doc for

mohanak — Wed, 18 Feb 2015 12:18:07 GMT

Find the attached doc for configuartion settings.

Refresh your WAP561firmware

gohussai — Fri, 27 Feb 2015 18:05:39 GMT

Refresh your WAP561firmware and backup your config before that.

after confgurating sheduling make sure its enable from console, normally due to some bug problems Gui don't show what console shows ,so reconfirm it from console side .