topic wireless discovery. in Wireless

wireless discovery.

jbuenomocisco — Sun, 04 Jul 2021 03:13:42 GMT

How can I configure the wireless not to be shown for users,but used by tham? On a Cisco 1242AG

I mean when someone do a wireless discovery not see my wireless name, but typing the name be able to connect it.

Re: wireless discovery.

Surendra BG — Fri, 20 May 2011 14:36:57 GMT

Hi,

If its autonomous based APs, then its just disable broadcast SSID..

conf t

dot11 ssid

no guest-mode

end

if its WLC based.. on the WLC >> WLAN >> Un check broadcast.

This will do it for you!!

lemme know if this answered ur question!!

Regards

Surendra

Re: wireless discovery.

jbuenomocisco — Fri, 20 May 2011 17:01:32 GMT

Sorry, can you help me a little more,

I look entire configurations through webpage, and I didn't see any configuration about broadcasting in my 1242AG page.

Re: wireless discovery.

Surendra BG — Fri, 20 May 2011 17:07:54 GMT

ok!!! from the GUI.. we need to do the below..

AP GUI >> Security >> SSID Manager >> Scroll down to the bottom >> Guest Mode/Infrastructure SSID Settings >> Single BSSID >> In the drop down Select NONE.

Just in case if we are using Multiple SSIDs, then

AP GUI >> Security >> SSID Manager >> Scroll down to the bottom >> Guest Mode/Infrastructure SSID Settings >> Multiple BSSID >> In the drop down Select NONE.

Lemme know if this helps and please dont forget to rate the useful posts!!

Regards

Surendra

Re: wireless discovery.

jbuenomocisco — Fri, 20 May 2011 18:02:07 GMT

Thank very much. Helped me a lots.

Re: wireless discovery.

Surendra BG — Sat, 21 May 2011 06:41:58 GMT

WoW!! Thats nice to hear... Please dont forget to rate the useful posts!!

Regards

Surendra