topic Re: Wireless Connection in Wireless

Wireless Connection

afernandez0226 — Sun, 04 Jul 2021 00:46:24 GMT

hi all,

i deployed a wireless network with 5 AP 1252 and 1 WLC 4402 to cover 22,000 sqf. the issue that am having is if i disconnect any of the 5 AP the whole wlan goes down

Re: Wireless Connection

Scott Fella — Sun, 28 Jun 2009 13:39:30 GMT

That shouldn't happen. On the CLI, do a show run-config not a show running-config and attach that to the post. There might be an issue with your configuration.

Re: Wireless Connection

afernandez0226 — Sun, 28 Jun 2009 16:31:44 GMT

Thanks for the quick reply. Attach my (Cisco Controller) >show run-config

Re: Wireless Connection

Scott Fella — Mon, 29 Jun 2009 02:31:01 GMT

Well I see you are using the 6.x.... pretty new. 4.2.130 & 4.2.205 seem pretty stable to me, but in your case,I would at least install the 5.2.157.0 ER image. The configuration looks fine. Have you had a previous code prior to moving to the 6.x, if so, did you have the issue you are having with the 6.x?

Re: Wireless Connection

afernandez0226 — Mon, 29 Jun 2009 02:56:44 GMT

Thanks for the reply.

After I received the wlc; i upgraded to 6.x before I started the configuration; I never used the configuration that came with it. Should I downgrade to 5.2.157?

Re: Wireless Connection

Scott Fella — Mon, 29 Jun 2009 03:07:59 GMT

You could open a TAC case if you want to see if that is an issue with 6.x or not. If you plan on downgrading, then I would go with 4.2.205. 5.x isn't a very stable code.

Re: Wireless Connection

Leo Laohoo — Mon, 29 Jun 2009 03:22:37 GMT

If you disconnect any one of your APs, the entire WLAN goes down or all the AP's go offline?

Have you tried the basic setup and build it up from there?

Re: Wireless Connection

afernandez0226 — Mon, 29 Jun 2009 03:25:20 GMT

thanks at lot for your help. I will open a TAC case, and post back the soluction.