topic MR CW9162I in repeater mode in Wireless

MR CW9162I in repeater mode

Abdullah_Pracha — Fri, 28 Jun 2024 12:20:39 GMT

Hey All,

My MR AP(CW916I) device switched to repeater mode. I rebooted it, but it remained in repeater mode. I replaced it with an identical MR, which worked fine on the same port. I then tested the original MR on another port in the network closet, but it still wasn't working and stayed in repeater mode. The next day, the new MR I had replaced switched to repeater mode, while the old one obtained an IP address and started working.
Does anyone ever got a same issue?

Re: MR CW9162I in repeater mode

aleabrahao — Fri, 28 Jun 2024 12:24:12 GMT

In most cases it is because the Access point did not receive an IP.

If you have already changed the cable and port on the switch, it is likely a hardware problem, so I suggest you open a support case for them to investigate.

Re: MR CW9162I in repeater mode

Abdullah_Pracha — Fri, 28 Jun 2024 12:28:49 GMT

I did opened a case, but they asked to do the layer1 stuff first which I did.
If this is a hardware issue then why the new one switched to repeater mode? and the older one started working.

Re: MR CW9162I in repeater mode

aleabrahao — Fri, 28 Jun 2024 12:32:57 GMT

So you have a network problem that you must identify.

For example, how is your DHCP scope? Have you already checked this?

Re: MR CW9162I in repeater mode

Karsten Iwen — Fri, 28 Jun 2024 12:42:52 GMT

A troubleshooting step for these types of problems is also to factory reset the device. Often, it starts to work again after that.

Re: MR CW9162I in repeater mode

Abdullah_Pracha — Tue, 02 Jul 2024 12:17:45 GMT

Ran a cable test, seems like one of the pair is not working.

Re: MR CW9162I in repeater mode

mahjouboi11 — Wed, 03 Jul 2024 09:49:09 GMT

It happened with me, probably it is a cable issue or switch port issue.