LWAPP migration question

c.walsh — Sat, 03 Jul 2021 22:15:21 GMT

We have migrated some 1242 APs to LWAPP.

They work fine, but when using the Aironet Site survey tool, the AP name & IP Address is not displayed. This is different to the autonomous APs that have not yet been converted. This is not a serious issue, but we would like to know if this can be configured via the WLC or not.

thanks

Colin

Re: LWAPP migration question

irisrios — Tue, 29 Jan 2008 15:01:24 GMT

Name and IP address of an AP is configurable via Controller. On controller GUI go to Wireless . You would get the list of access point that are joined to that controller. Click on Detail section of an access point. Name and IP addresses are configurable there.

Re: LWAPP migration question

Manjunatha Jayaram — Thu, 31 Jan 2008 17:24:38 GMT

hi, i want to convert the Product/Model Number: AIR-LAP1131AG-A-K9 into standalone Access Point as it is working as LWAPP,so can u help me out .

Re: LWAPP migration question

Rob Huffman — Thu, 31 Jan 2008 18:30:21 GMT

Hi RN,

Here is the method 🙂

Reverting the Access Point Back to Autonomous Mode

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html#wp161272

You can convert an access point from lightweight mode back to autonomous mode by loading a Cisco IOS Release that supports autonomous mode (Cisco IOS release 12.3(7)JA or earlier). If the access point is associated to a controller, you can use the controller to load the Cisco IOS release. If the access point is not associated to a controller, you can load the Cisco IOS release using TFTP.

Using a TFTP Server to Return to a Previous Release

Follow these steps to revert from LWAPP mode to autonomous mode by loading a Cisco IOS release using a TFTP server:

--------------------------------------------------------------------------------

Step 1 The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.

Step 2 Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.

Step 3 Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, and c1240-k9w7-tar.default for a 1240 series access point.

Step 4 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.

Step 5 Disconnect power from the access point.

Step 6 Press and hold MODE while you reconnect power to the access point.

Step 7 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.

Step 8 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.

Step 9 After the access point reboots, reconfigure it using the GUI or the CLI.

From this doc;

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html#wp161272

Hope this helps!

Rob

topic LWAPP migration question in Wireless

LWAPP migration question

Re: LWAPP migration question

Re: LWAPP migration question

Re: LWAPP migration question