topic Re: Issue with Access Points Functioning as Repeaters Post-Update in Wireless

Issue with Access Points Functioning as Repeaters Post-Update

Repeater-mode — Mon, 19 Feb 2024 13:51:01 GMT

Hi all,

Following the latest update, some of the APs have unexpectedly transitioned into repeater mode. Despite performing reboots on the affected units, the problem persists, with the APs persistently acting as repeaters.

This deviation from their prior functionality is concerning, especially considering that all units were operating correctly before the update.

I'm reaching out to inquire if any of you have encountered similar challenges post-update. Please share any observations or suggestions you might have regarding this matter.

It's 4 out of 187 AP's acting this way..

Re: Issue with Access Points Functioning as Repeaters Post-Update

aleabrahao — Mon, 19 Feb 2024 14:53:58 GMT

I suggest you open a support case.

Re: Issue with Access Points Functioning as Repeaters Post-Update

Rasmus Hoffmann Birkelund — Mon, 19 Feb 2024 15:33:12 GMT

Perhaps disable Meshing on the Network-Wide configuratino page, if you don't want Meraki to automatically mesh incase of missing uplink connection.

Re: Issue with Access Points Functioning as Repeaters Post-Update

ppurroy — Mon, 19 Feb 2024 15:59:14 GMT

You might be hitting the condition discussed in this thread:

https://community.meraki.com/t5/Wireless-LAN/Firmware-Network-Issue-MR30-5/m-p/220995#M30594