https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529859#M311538 <P>Hi,</P><P>If I only want to have 5 GHz coverage, is it allowed to use the MR74 with a single ANT-27?</P> Wed, 29 May 2019 12:57:55 GMT nyuszy 2019-05-29T12:57:55Z https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529857#M311536 <P>Hi!</P><P>On wich Ports (2,4 GHz or 5 GHz) can i connect the ANt27?</P><P>thx</P><P>Richard</P> Thu, 09 Nov 2017 10:32:58 GMT https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529857#M311536 Koal 2017-11-09T10:32:58Z https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529858#M311537 <P>You can connect the ANT-27 for either frequency, ANT-27 is a dual band sector. On the MR74, 2 ports are for the 2x2:2 2.4GHz radio and the other 2 ports are for the 5GHz 2x2:2 radio. So just make sure you're plugging the ANT-27 into the 2 ports on the SAME side of the AP. Even though the ANT-27 is dual-band, you'll basically be using it as a band-specific sector antenna, because on the MR74, the antenna ports are single band, two for 2.4 GHz and two for 5 GHz. So you would use 2 ANT-27 antennas per MR74 AP to provide the dual-band coverage.</P> Thu, 09 Nov 2017 16:21:30 GMT https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529858#M311537 daviscot 2017-11-09T16:21:30Z https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529859#M311538 <P>Hi,</P><P>If I only want to have 5 GHz coverage, is it allowed to use the MR74 with a single ANT-27?</P> Wed, 29 May 2019 12:57:55 GMT https://community.cisco.com/t5/wireless/mr74-ant27/m-p/5529859#M311538 nyuszy 2019-05-29T12:57:55Z