IPv6 for wifi Clients

pat.mchenry — Mon, 05 Jul 2021 16:30:11 GMT

Hi,

I would like to enable IPv6 for an office WLAN.

At present we have a dual stack network on a wired FLAT LAN (the WLAN shares the same Subnet/VLAN). Developers use IPv6 on the LAN mostly for testing, but at present must patch into a wired Ethernet port to use it. It would be handy for them to utilize the IPv6 network while on the WLAN.

The wireless is a single AP running the MEC software and acting as the office AP /Controller

What configuration changes must I make to allow IPv6 on the WLAN? Should it work by default?

Is there a way to enable it in the GUI? Or, must I enable in CLI?

Thank you, Pat

Re: IPv6 for wifi Clients

Rasika Nayanajith — Tue, 27 Nov 2018 02:37:45 GMT

If it is a Mobility Express AP, pls follow below guide

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/ipv6.html

HTH

Rasika

*** Pls rate all useful responses ***

topic IPv6 for wifi Clients in Wireless

IPv6 for wifi Clients

Re: IPv6 for wifi Clients