SNMP on Flexconnect Access Points

jacovr — Mon, 05 Jul 2021 10:20:01 GMT

I'm configuring SNMP on my Flexconnect Access Points.

I configure the SMNP settings on the AP cli, and all is working 100%.

As soon as I reboot the AP, the SNMP Config is gone (the rest of the config is still there)

It seems it is being override by the WLC, but I cant seem to find what/where it is ? Am I missing something here ?

========
Config
========

snmp-server group tsssupportcojWireless v3 auth write tsssupportcojWireless
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server enable traps tty
snmp-server enable traps entity
snmp-server enable traps cpu threshold
snmp-server enable traps cef resource-failure peer-state-change peer-fib-state-change inconsistency
snmp-server enable traps vrfmib vrf-up vrf-down vnet-trunk-up vnet-trunk-down
!

222_AP#sh snmp user

User name: tsssupportcojWireless
Engine ID: 80000009030058BFEA4118E0
storage-type: nonvolatile active
Authentication Protocol: MD5
Privacy Protocol: None
Group-name: tsssupportcojWireless

222_AP#

==============
After Reboot:
==============

222_AP#sh snmp user
%SNMP agent not enabled
222_AP#

That is because the AP

Scott Fella — Mon, 01 Jun 2015 11:02:37 GMT

That is because the AP configuration comes from the WLC. Any CLI commands will work until the AP is rebooted and there is no workaround for that. If you search the forum, you will see others have ran into that same issue after a reboot.

-Scott

Thanx. But. How do I monitor

jacovr — Mon, 01 Jun 2015 11:05:41 GMT

Thanx. But. How do I monitor my APs through SNMP then ?

topic SNMP on Flexconnect Access Points in Wireless

SNMP on Flexconnect Access Points

That is because the AP

Thanx. But. How do I monitor