topic Re: CLI Login CAPWAP accesspoint associated in WLC in Wireless

CLI Login CAPWAP accesspoint associated in WLC

snarayanaraju — Mon, 05 Jul 2021 16:11:17 GMT

Hello All - How to do CLI Login of CAPWAP Wireless accesspoint that is already associated with a WLC. Though telnet is enabled, when tried login the accesspoint using the IP address of the accesspoint, it prompts for credential,

default credential "cisco/cisco" or the credential i use for login to WLC doesnt allow me to login the Accesspoint.

Appreciate if you can help me on this

regards/sairam

Re: CLI Login CAPWAP accesspoint associated in WLC

Rasika Nayanajith — Fri, 14 Sep 2018 20:09:13 GMT

Did you try Cisco/Cisco ?

Rasika

Re: CLI Login CAPWAP accesspoint associated in WLC

snarayanaraju — Sun, 16 Sep 2018 06:46:19 GMT

Thanks Rasika - No it doesnt work. Cisco / Cisco fails

Re: CLI Login CAPWAP accesspoint associated in WLC

Rasika Nayanajith — Sun, 16 Sep 2018 06:55:26 GMT

In WLC, select that AP & under credential tab, you can override it. Defined a username, password & enable password & hit apply. Then try to use that newly setup credential for that AP

If you like to change credential for all your APs, you can do that under global configuration in wireless tab

That should work

HTH

Rasika

*** Pls rate all useful responses ***

Re: CLI Login CAPWAP accesspoint associated in WLC

snarayanaraju — Sun, 16 Sep 2018 16:00:35 GMT

Excellent. It worked.

Thanks again Rasika. You are great