WLC ethernet bridge

filip00011 — Mon, 05 Jul 2021 14:20:55 GMT

I want to achieve what is on the picture.

I have got WLC 2504 and 2 access points 1702. Is it possible?

you can do this without

Ambuj M — Mon, 17 Jul 2017 14:33:30 GMT

you can do this without controller, convert both to autonomous mode, follow this post if you run into any issue converting to autonomous mode.

https://supportforums.cisco.com/discussion/12336596/how-convert-ap-1700-2700-lightweight-mode-autonomous-mode

once converted, you can configure one AP as root other AP as non-root, I would also recommend you to configure some form of security for instance non-root should authenticate through 802.1x with root before joining, using a local user database on root.

Follow the link below for configuration example.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68087-bridges-pt-to-pt.html

If you want to use controller you can do ethernet bridging over mesh, see the link below.

http://www.cisco.com/web/services/news/ts_newsletter/tech/chalktalk/archives/200911.html

I have personally done option 1 with a different AP model, keep in mind to take consideration RF parameters like EIRP, LOS etc for wireless bridging.

Rate helpful posts !

yes you can achieve.

Sandeep Choudhary — Tue, 18 Jul 2017 11:56:22 GMT

yes you can achieve.

Check these posts:

https://rscciew.wordpress.com/2014/08/15/wgb-with-multiple-vlan-in-uwns/

http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/100254-wgb-config.html

Regards

Dont forget to rate helpful posts

topic WLC ethernet bridge in Wireless

WLC ethernet bridge

you can do this without

yes you can achieve.