topic 2504 WLC in Wireless

2504 WLC

supierz.kamil — Mon, 05 Jul 2021 14:17:54 GMT

I have a problem with two 2504 controllers. Problem description: WLC1 supports AP AP WLC2 5 AP. Both broadcast the same network. If I move between AP WLC1 to WLC2 AP device connects to the network if it reverts to AP WLC1 then the device connects where it may be a problem

Pls explain it further,

Rasika Nayanajith — Thu, 06 Jul 2017 21:03:06 GMT

Pls explain it further,

I did not understand it properly to comment.

Rasika

I have a problem with two

supierz.kamil — Fri, 07 Jul 2017 09:02:25 GMT

I have a problem with two 2504 controllers. Problem description: WLC1 supports AP AP WLC2 5 AP. Both broadcast the same network. If I move between AP WLC1 to WLC2 AP device connects to the network and everything is ok but if device back to the to AP WLC1 then the device cant connect. And i must restart the device (laptop, or pc

)

Have you configured Mobility

Rasika Nayanajith — Fri, 07 Jul 2017 09:46:34 GMT

Have you configured Mobility between WLC1 and WLC2.

Pls check below post and you will understand how you can configure it via CLI . You can do the same via GUI as well (refer config guide if you like to do it via GUI)

https://mrncciew.com/2013/05/20/mobility-config-via-cli/

"show mobility summary" output verify your peering config.

HTH

Rasika

*** Pls rate all useful responses ***