topic May be you set the read-only in Wireless

WLC-5500 Authorization failed. no sufficient privileges to save configuration

winaicas1 — Mon, 05 Jul 2021 12:13:26 GMT

Help me!

I have Cisco 5500 Version 7.5
I log in using the admin settings
But can not save save config

Thank you

May be you set the read-only

Sandeep Choudhary — Tue, 14 Jun 2016 05:43:06 GMT

May be you set the read-only privileges for the admin user in RADIUS SERVER !!!

Please check again.

Check this posts, it may helps:

https://rscciew.wordpress.com/2014/06/19/wlc-authentication-by-ise-server/

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71989-manage-wlc-users-radius.html

Regards

Dont forget to rate helpful posts

Use it to set up a user admin

winaicas1 — Wed, 15 Jun 2016 02:43:44 GMT

Use it to set up a user admin can manage it. But it still does not fix the system.

Did you configure RADIUS

Sandeep Choudhary — Wed, 15 Jun 2016 06:04:48 GMT

Did you configure RADIUS server correctly, please check my last post and try to recheck again.

https://rscciew.wordpress.com/2014/06/19/wlc-authentication-by-ise-server/

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/71989-manage-wlc-users-radius.html

Your Auth order is First RADIUS and then Local. So if If LOCAL is selected as second priority then user will be authenticated against LOCAL only if first priority is unreachable.

Regards

Dont forget to rate helpful posts

In this case, however, I can

winaicas1 — Sat, 18 Jun 2016 08:52:57 GMT

In this case, however, I can fix it.
I Selection Priority Order> management User First is Radius ????.
I got into the mode console irreparable.

I use Freeradius + openldap

***Normally the user admin in local wlc.

Thank you

succeeded.

winaicas1 — Thu, 23 Jun 2016 03:32:25 GMT

succeeded.

By disconnecting radius.

Making adjustments Priority Order> management User First is Local