topic YES in Wireless

Cisco WLC Controllers in the same network

mikiNet — Mon, 05 Jul 2021 08:47:12 GMT

Hi All,

I have a one question. If it possible to run two Cisco WLC Controllers in the same subnet network ? I asking you because at this moment I have one WLC but it support only 25 AP and this licence pool has completely run out. I have additional Cisco WLC with 5 AP support. Can I put new WLC to the same network where old WLC working ?

Yes, you can. Make sure you

Rasika Nayanajith — Thu, 23 Oct 2014 08:32:37 GMT

Yes, you can. Make sure you configure same mobility group name , rf-group name & virtual interface IP in both WLCs with mobility peering.

You can control which WLC is primary & which one is secondary for a given AP under High Availability tab of AP configuration.

HTH

Rasika

**** Pls rate all useful responses ****

Thanks !! :) Best regards

mikiNet — Thu, 23 Oct 2014 13:07:50 GMT

Thanks !! 🙂

Best regards,

Bartek

I have additional question.

mikiNet — Mon, 03 Nov 2014 08:24:40 GMT

I have additional question. So If I have Cisco WLC 2504 with support 25 AP, it is possible to increase number AP from 25 to 30 through buy additional licence for 5 AP and install this licence on Cisco WLC?

YES

Rasika Nayanajith — Mon, 03 Nov 2014 08:29:03 GMT

YES,

If you get 5 AP adder licences (something like L-LIC-CT2504-5A), you should be able to increase AP count from 25-30

HTH

Rasika

**** Pls rate all useful responses ***