WLC ethernet bridge

Maurice Ball — Sun, 04 Jul 2021 06:39:51 GMT

Hi,

I've a WLC 2106 and it is running IOS version 7.0.240. I am trying to setup a wireless mesh and used the ethernet bridge port on the MAP to extend the network. The wireless mesh works fine but I can not get the switch to work that is connected to the ethernet port on the MAP.

I'm using two different Access points. I'm using a Air Cap 3502i as the RAP and a Air Lap1142N as the MAP.

The switch port that is connected to the RAP and MAP is configured as the following:

switchport mode trunk

switchport trunk native vlan 2

switchport trunk allowed vlan 10,20,30,40

The RAP etherbridge port is enable and set to: normal

The MAP etherbridge port is enable and set to: Trunk,

native vlan is set to: 2

Vlan id 10

Vlan id 20

The wireless mesh between the RAP and MAP works fine. I can connect a device to the MAP wirelessly and access the network with no problem but I can not get anything to work that connects to the switch that is connected to the MAP ethernet port.

Could someone please tell me what I'm doing wrong?

Re: WLC ethernet bridge

Scott Fella — Mon, 04 Mar 2013 13:16:37 GMT

I would open a TAC case as this is a bug. I don't recall what code it stopped working but I know it doesn't work also in the v7.3 & v7.4

Sent from Cisco Technical Support iPhone App

WLC ethernet bridge

Maurice Ball — Sat, 09 Mar 2013 06:35:32 GMT

thanks for the help.

topic Re: WLC ethernet bridge in Wireless

WLC ethernet bridge

Re: WLC ethernet bridge

WLC ethernet bridge