topic Re: WLC easy question in Wireless

WLC easy question

stephen jeffrey — Sun, 04 Jul 2021 06:35:22 GMT

Hi, Ive got a WLC and stupidly highlighted an AP and selected remove AP. how do I get it to register again withthe controller. WLC is version 7.0.116.0

Re: WLC easy question

Scott Fella — Thu, 21 Feb 2013 13:09:28 GMT

How did you remove an AP? I don't see anything to remove an AP from the WLC. Connect the AP to the same subnet as the WLC and console into the AP and post the output from boot up.

Sent from Cisco Technical Support iPhone App

Re: WLC easy question

Scott Fella — Thu, 21 Feb 2013 13:11:59 GMT

Make sure on the Security | AAA | AP Policies tab that you don't have the last two checkbox enabled. By default, Accept Manufactured Installed Certificate (MIC) is the only one checked.

Sent from Cisco Technical Support iPhone App

Re: WLC easy question

stephen jeffrey — Thu, 21 Feb 2013 13:16:40 GMT

Sorry, It wasnt until I went back through the steps I realised that Im using WCS to manage the WLC. I removed the access point from there.

WLC easy question

Scott Fella — Thu, 21 Feb 2013 14:06:36 GMT

Well you can add the access point back on the map if that is where you removed it.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"