topic Re: WLC and AP Interfaces statistics in Wireless

WLC and AP Interfaces statistics

cnrs-dsi — Sun, 04 Jul 2021 02:41:09 GMT

Hello

I want to clear ethernet interfaces statistics from APs.

ALL AP/ Detail for AP XXX / interfaces / interface detail.

I can't found how to do that.

I have tried claer ap, clear stats ...no result

Thanks for help

Re: WLC and AP Interfaces statistics

Surendra BG — Mon, 17 Jan 2011 13:54:52 GMT

Hi,

Default the interface and this will do it..

The command is ..

conf t# default interface fa 0

end

lemme know if this answered your question..

Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull

Re: WLC and AP Interfaces statistics

cnrs-dsi — Mon, 17 Jan 2011 14:30:10 GMT

Hello Surendra

I am on a WLC 4002 and my AP are ligthweight AP.

I have no "conf t" possibility

I want to clear results of :

(Cisco Controller) >show ap stats ethernet summary

AP                   Interface Name    Status Speed Rx Packets Tx Packets Discards
-------------------- --------------    ------ ----- ---------- ---------- --------
ap1                   GigabitEthernet0   UP     100    2353053     860421      0
apt2                  GigabitEthernet0   UP     1000   3982738     2062225     0

Re: WLC and AP Interfaces statistics

Surendra BG — Mon, 17 Jan 2011 15:06:18 GMT

Hi,

I never knew that you were using the LWAPP APs if so, we need to login to the AP and issue the same command..

That is..

AP#debul capwap console cli (This hidden command will help you out in getting into the config mode on the LWAPP AP)

AP#debul lwapp console cli (This hidden command will help you out in getting into the config mode on the LWAPP AP)

AP#config t

Ap(conf t)#default interface fa 0

this may help you..

Or from the WLC.. here is the command..

WLC>config ap telnet enable

wlc> debug ap command "default interface fa 0"

This may help you!!

lemme know if this answered your question..

Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull

Re: WLC and AP Interfaces statistics

cnrs-dsi — Tue, 18 Jan 2011 08:11:00 GMT

It's ok.

thanks for your help.

I enable telnet on the ap and make a clear counters.