topic Re: WLC 4402 in Wireless

WLC 4402

MCIT- IT MCIT- IT — Sun, 04 Jul 2021 01:34:29 GMT

i have cisco wireless controller 4402 series, i wanted to upgrade it to higher versions, current version is 4.0.179.11, i wanted to go to version 6.x, i should go to mid version in between, but its refuse all the time the new image for some reasons which i dont know, there is 2 imgaes currently on the WLC pri and sec. and both are same version.

any one faced the same issue or know how to solve it?

Thanks and Regards

Majdi

Re: WLC 4402

Scott Fella — Wed, 03 Mar 2010 19:25:27 GMT

Here is a document that will explain what version you can upgrade to from an existing version. This should get you to 6.x

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00805f381f.shtml#conf

Re: WLC 4402

Leo Laohoo — Wed, 03 Mar 2010 21:25:53 GMT

Have you gone through the release notes of the firmware you wanted to go to? Kindly read the section posted below. It will give you a brief description on the firmwares you need to install FIRST prior to full upgrade.

Special Rules for Upgrading to Controller Software
http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn6_0_196.html#wp233853

Re: WLC 4402

MCIT- IT MCIT- IT — Thu, 04 Mar 2010 07:29:12 GMT

Hi,

I already checked the links attached , and went into the procedures step by step, the issue is when uploading the image file with tftp client, i am getting this error : Sanity check failed on file. The file was not downloaded completely , accourding to the manuals it means that the tftp not supporting more than 33 M files, i tried lot of TFTP softwares even the ons cisco recomends in the document tftpd32 i am getting the same error.

Thanks

Re: WLC 4402

Leo Laohoo — Thu, 04 Mar 2010 11:27:33 GMT

Try downloading the firmware again, maybe it's corrupt.

Re: WLC 4402

Scott Fella — Thu, 04 Mar 2010 12:50:19 GMT

I use 3CDeamon and never had any issues. You are also upgrading to 4.2.176.0 first correct? Like leolaohoo mentioned, try to download the image again.

Re: WLC 4402

MCIT- IT MCIT- IT — Mon, 08 Mar 2010 07:50:28 GMT

I downloaded the image again , and tried 3CDeamon, same problem

Re: WLC 4402

Scott Fella — Mon, 08 Mar 2010 14:07:25 GMT

Try to tftp the image you currently have on your WLC and see if that fial or not. Have you tried another PC/laptop with tftp?