how to enable HTTPS on a wlc-2100

axfalk — Sat, 03 Jul 2021 21:50:43 GMT

Can someone please let me know the command to enable the HTTPS on a wlc from cli?

thanks..

Re: how to enable HTTPS on a wlc-2100

Rob Huffman — Fri, 26 Oct 2007 17:44:21 GMT

Hi Greg,

Here is the method;

Using the CLI, follow these steps to enable HTTPS:

--------------------------------------------------------------------------------

Step 1 Enter show certificate summary to verify that the controller has generated a certificate:

>show certificate summary

Web Administration Certificate................. Locally Generated

Web Authentication Certificate................. Locally Generated

Certificate compatibility mode:................ off

Step 2 (Optional) If you need to generate a new certificate, enter this command:

>config certificate generate webadmin

After a few seconds the controller verifies that the certificate is generated:

Web Administration certificate has been generated

Step 3 Enter this command to enable HTTPS:

>config network secureweb enable

Step 4 Save the SSL certificate, key, and secure web password to NVRAM (non-volatile RAM) so your changes are retained across reboots:

>save config

Are you sure you want to save? (y/n) y

Configuration Saved!

Step 5 Reboot the controller:

>reset system

Are you sure you would like to reset the system? (y/n) y

System will now restart!

The controller reboots.

From this good doc;

Hope this helps!

Rob