topic Re: WLC 4400 dot1x in Wireless https://community.cisco.com/t5/wireless/wlc-4400-dot1x/m-p/643984#M49977 <HTML><HEAD></HEAD><BODY><P>Hello,</P><P></P><P>Your show-run is not complete so it is hard to see your interface/vlans you are using. Have you checked STP? If your wireless network is on the same vlan as your wired you potentially can run into a loop issue.</P><P></P><P>-Mark</P></BODY></HTML> Tue, 26 Dec 2006 11:57:11 GMT magress 2006-12-26T11:57:11Z WLC 4400 dot1x https://community.cisco.com/t5/wireless/wlc-4400-dot1x/m-p/643983#M49976 <P>hi,</P><P></P><P>i am facing a starnge issue. My wireless works all of fine with MS IAS as radius server dot1x authenstication. But the problem comes when i add an interface on controller from vlan 1 (i.e.same of where my Radius server exist) After this interface is created all of my dot1x wireless setup stops working for all. And also does not work for the new interface vlan 1 network also. My servers and users wired network is on vlan 1. </P><P></P><P> </P><P></P> Sat, 03 Jul 2021 20:25:13 GMT https://community.cisco.com/t5/wireless/wlc-4400-dot1x/m-p/643983#M49976 bws 2021-07-03T20:25:13Z Re: WLC 4400 dot1x https://community.cisco.com/t5/wireless/wlc-4400-dot1x/m-p/643984#M49977 <HTML><HEAD></HEAD><BODY><P>Hello,</P><P></P><P>Your show-run is not complete so it is hard to see your interface/vlans you are using. Have you checked STP? If your wireless network is on the same vlan as your wired you potentially can run into a loop issue.</P><P></P><P>-Mark</P></BODY></HTML> Tue, 26 Dec 2006 11:57:11 GMT https://community.cisco.com/t5/wireless/wlc-4400-dot1x/m-p/643984#M49977 magress 2006-12-26T11:57:11Z