topic Wireless Mesh Networks - AIR-BAND-INST-TL= in Wireless

Wireless Mesh Networks - AIR-BAND-INST-TL=

mlouis — Sun, 04 Jul 2021 00:45:32 GMT

I am getting ready to install a mesh network for the first time. Do I need more than 1 of these tools?

Re: Wireless Mesh Networks - AIR-BAND-INST-TL=

mlouis — Wed, 24 Jun 2009 12:43:04 GMT

Do these tool break easily? They are quite expensive.

Thanks so much

Re: Wireless Mesh Networks - AIR-BAND-INST-TL=

ehlers.kevin — Wed, 24 Jun 2009 21:46:43 GMT

They seem pretty robust to me. We have a few, but that was mainly in case we dropped or lost one. It was used for about 5 installs.

The only weirdness we ran into was making sure we actually locked the strap in place. We burned through a few install kits because we didn't fold it backwards to compress the fitting.

Re: Wireless Mesh Networks - AIR-BAND-INST-TL=

mlouis — Thu, 25 Jun 2009 00:33:41 GMT

When you say kit, are you referring to the tool or the pole mount kit?

Re: Wireless Mesh Networks - AIR-BAND-INST-TL=

ehlers.kevin — Thu, 25 Jun 2009 04:50:43 GMT

Ah yes, I see how that was confusing. I was referring to the pole mounting kit. Specifically to the metal straps/bands that attach the mount to the pole.

If you cinch it down, forget to "clamp it/fold it back and lock it down", and then cut the straps. You'll need some more straps when you figure out it's lose. 🙂

I think it was a by-product of the electrician who installed it. He didn't read the mounting instructions, and assumed he could figure it out while up on the lift.

Re: Wireless Mesh Networks - AIR-BAND-INST-TL=

dennischolmes — Thu, 25 Jun 2009 11:24:45 GMT

Any commercial band strapping tool should work. Cable and power companies buy them from third party vendors much less expensively than the Cisco part number.

Wireless Mesh Networks - AIR-BAND-INST-TL=

asif.naveed — Tue, 15 Nov 2011 09:24:50 GMT

Hi,

Any one can guide me that i want to use AIR-BAND-INST-TL= qtu 01 for 50 APs.

As per my understanding this is not required per AP basis.

Only one is enough for ALL.

Regards

Wireless Mesh Networks - AIR-BAND-INST-TL=

dennischolmes — Tue, 15 Nov 2011 12:54:01 GMT

This is the band tool used to install the banded mount for the AP to a pole. As stated above you can achieve this with only one tool but you may want to equipt more than one install team. Cabling companies buy these tools at a much reduced rate through popular cabling vendors. I would look to a cable distributor for a less costly tool.