topic if you have run the initial in Wireless

MSE WEB GUI access

mcaoile — Mon, 05 Jul 2021 12:55:39 GMT

Hello,

The MSE (3365) is in standalone and not joined to Cisco Prime. I tried to access the MSE thru web gui using https://ipaddress/mseui/.

I get a login screen (username and password). I used the username: root and the corresponding password and I got 'login failed'. If I SSH with

the same username and password, I get logged in. What login credentials must I use for web gui?

Also, I tried to check what are the licences installed in the MSE using the command below and I get a message : -bash: /opt/mse/licensing: is a directory. What could be the correct command to check the licenses?

[root@ksa-mse3365-1 ~]# /opt/mse/licensing
-bash: /opt/mse/licensing: is a directory
[root@ksa-mse3365-1 ~]#

I have attached the server info.

Regards,

Manuelito

should be

Yuk Tun Fong — Thu, 13 Oct 2016 05:01:31 GMT

should be

admin/admin

if you don't change the password/

if you have run the initial

pieterh — Fri, 14 Oct 2016 10:43:35 GMT

if you have run the initial setup for the mse it must have asked for entering the web-gui credentials.!

you can rerun the setup from the cli for a new username/password

/opt/mse/setup/setup.sh

What is the purpose of using the mse in stand-alone config?

- add it to prime

- register your license

- manage it from the prime gui