topic access point 1700 series in Wireless

access point 1700 series

moh_efrangi — Mon, 05 Jul 2021 11:19:10 GMT

i am facing a problem with one Access point that the flash is empty without any image , the access point start in the rommon mode how i can download an image in the flash ?
what is the steps for that ??

the access point model is 1700

thanx

Hi,

Sandeep Choudhary — Sat, 28 Nov 2015 15:57:05 GMT

Hi,

follow this link:

https://supportforums.cisco.com/document/56156/access-point-rommon-recovery-ap-prompt-recovery-example

Regards

Dont forget to rate helpful posts

thanks

moh_efrangi — Sat, 28 Nov 2015 20:34:49 GMT

thanks

i already try these command but after step 6 nothing happened and give me message session timed out so is there a particular name for the image

ap: tar -xtract tftp://x.x.x.x/images/ ap3g2-k9w7-tar.153-3.JBB flash

this is what i try .

Your tftp root folder might

Scott Fella — Sun, 29 Nov 2015 16:41:48 GMT

Your tftp root folder might be the issue. If the image is not in the image folder, then your path is incorrect. If the file is in the tftp root folder, then you need to remove the image/ in the file path.

Example:

ap: tar -xtract tftp://x.x.x.x/ap3g2-k9w7-tar.153-3.JBB flash

-Scott

Hi,

Sandeep Choudhary — Sun, 29 Nov 2015 19:37:58 GMT

Hi,

May be you need to run this command:

ap: tar -xtract tftp://x.x.x.x/images/ ap3g2-k9w7-tar.153-3.JBB.tar flash

Regards

Dont forget to rate helpful posts