topic i don't have an access on the in Wireless

Access point cannot join to the controller

moh_efrangi — Mon, 05 Jul 2021 10:15:28 GMT

hello

I have a 100 access point (AIR-CAP3702i),99 are joined to the controller 5508 version 7.6.130 and take the same version of the controller except

one of them it take 7.6.118 and all configuration is the same .

the behavior of the access point is connect and disconnect it take an IP but just for two minute not more and no client can join .

where is the problem ? any one face the same issue ?

if you have access to AP

Rasika Nayanajith — Tue, 19 May 2015 22:26:29 GMT

if you have access to AP console, pls attach the complete output when it is trying to register.

Rasika

i don't have an access on the

moh_efrangi — Wed, 20 May 2015 05:29:20 GMT

i don't have an access on the time , but on your experience can i change the image manually for the access point and if i can what is the right version

Moh

get the debug detail from

Saurav Lodh — Wed, 20 May 2015 15:25:00 GMT

get the debug detail from console output of Controller and LAP

http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/99948-lap-notjoin-wlc-tshoot.html

it appear that the image

moh_efrangi — Sun, 24 May 2015 07:46:22 GMT

it appear that the image cannot boot probably ,after change it the behavior of the access point is shutting down ,so i open a case for RMA and change it

thanks alot for your interest

Moh