topic wism cannot access through web in Wireless

wism cannot access through web

susim — Mon, 05 Jul 2021 06:53:52 GMT

Hi ,

One of the wism controller in the module cannot access throuh the web interface . ( ican access the second controller in the same module without any problem )

It may work after 2 -3 reboot or power off the module for sometimes .After sometime the same problem happens

Operational Status of the Controller : Oper-Up

Modular switch model : C6513

Please help

Thanks

wism cannot access through web

Leo Laohoo — Mon, 06 Jan 2014 09:42:22 GMT

Post the output to the command "sh wism module X controller Y status".

wism cannot access through web

susim — Mon, 06 Jan 2014 09:59:40 GMT

Operational Status of the Controller : Oper-Up

Service VLAN : 200

Service Port : 9

Service Port Mac Address : 001a.xxxx.xxxx

Service IP Address : 172.10.129.3

Management IP Address : 10.0.2.10

Software Version : 4.2.207.0

Port Channel Number : 525

Allowed-vlan list : 14,27,37-41

Native VLAN ID : 27

WCP Keep Alive Missed : 0

wism cannot access through web

Leo Laohoo — Mon, 06 Jan 2014 10:04:25 GMT

Software Version : 4.2.207.0

I think you need to upgrade the firmware of your controller.

It may work after 2 -3 reboot or power off the module  for sometimes .After sometime the same problem happens

This description is typical of a firmware bug. If you need to choose a good version, go with 7.0.240.X.

Don't forget to upgrade the bootstrap.

wism cannot access through web

Sandeep Choudhary — Mon, 06 Jan 2014 10:04:40 GMT

Hi,

Can u please paste the output of the command: show network status

If you sse these commands is disabled then please enabled it agin :

WLC > config network ssh enable

WLC > config network webmode enable

WLC > config network secureweb enable

There was a bug in the wisms and the workaround was to reload the controller.

If u have 2 wism then please Move over the APs and reload that WLC , that should fix it.

Hope it helps.

Regards

wism cannot access through web

susim — Mon, 06 Jan 2014 10:25:43 GMT

We use ap1020 (aironet) , we tried to upgrade the controller .Once the controller upgraded AP'S are not connecting to the controller

Re: wism cannot access through web

Sandeep Choudhary — Mon, 06 Jan 2014 10:27:47 GMT

Lat IOS support for 1020 AP is 4.2.209.0.

check this mtrix sheet: http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_notes/Wireless_Software_Compatibility_Matrix.html

Regards

wism cannot access through web

Leo Laohoo — Mon, 06 Jan 2014 10:31:15 GMT

We use ap1020 (aironet) , we tried to upgrade the controller .Once the controller upgraded AP'S are not connecting to the controller

Hmmmm ... Maybe the issue could be the version of your web browser.