topic Re: Cisco WLC 5520 adder license question in Wireless

Cisco WLC 5520 adder license question

Robert Edge — Mon, 05 Jul 2021 14:35:59 GMT

Greetings:

We have 47 sites using a pair of 5520 SSO for FlexConnect. When I add my new RTU 3 Ap license for a small branch the message returned by the WLC said reboot required. Can I ignore this? It’s an operation nightmare to reboot, requires change management and service disruption notices. I thought I read somewhere reboot not required.

Re: Cisco WLC 5520 adder license question

Flavio Miranda — Thu, 31 Aug 2017 03:27:49 GMT

that´s correct. We can see this on Cisco doc. For RTU they dont ask to reboot, but

Before it was requested.

Re: Cisco WLC 5520 adder license question

xtreme — Thu, 24 Jan 2019 05:23:18 GMT

Hi Robert,

Just wondering how the AP adder turned out. I am in a similar situation. Cisco doc says just save config but after hitting the set count button..a message popped up that reboot is necessary. if you did reboot,since its in HA, am guessing you had to reboot both controller one time. Appreciate your feedback in advance.

Re: Cisco WLC 5520 adder license question

Scott Fella — Thu, 24 Jan 2019 05:27:44 GMT

You can always just issue a force switchover on the primary and then wait for the primary to come up and sync. Then issue a force switchover again so that your primary becomes active.