AP not Registering

Patrick McHenry — Mon, 05 Jul 2021 11:00:03 GMT

Hi,

trying to get an AP to register with the controller, but it aint happening. I was reading an old post:

https://supportforums.cisco.com/discussion/12503981/cisco-air-ap3702i-uxk9-flashing-redgreenoff-registered-wlc

and it mentions that the AP is un-primed? Does this mean it has to be primed before it will join the controller. I can see the AP using cdp:

Device ID: APd8b1.900d.8e0c.amr.smtf.ds
Entry address(es):
IP address: 10.3.68.120
Platform: cisco AIR-AP3702I-UXK9, Capabilities: Trans-Bridge Source-Route-Bridge
Interface: GigabitEthernet1/0/24, Port ID (outgoing port): GigabitEthernet0
Holdtime : 149 sec

Version :
Cisco IOS Software, C3700 Software (AP3G2-RCVK9W8-M), Version 15.3(3)JA3, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Thu 19-Feb-15 10:27 by prod_rel_team

advertisement version: 2
Duplex: full
Power drawn: 16.800 Watts
Power request id: 12297, Power management id: 2
Power request levels are:16800 15400 13000 0 0
Power Available TLV:

Power request id: 0, Power management id: 0, Power available: 0, Power management level: 0
Management address(es):
IP address: 10.3.68.120

The other AP at the site is:

Platform: cisco AIR-CAP3702I-A-K9, Capabilities: Router Trans-Bridge - this AP has joined with problem.

Thanks you, Pat

Read THIS.

Leo Laohoo — Sat, 26 Sep 2015 00:59:05 GMT

Read THIS.

topic AP not Registering in Wireless

AP not Registering

Read THIS.