topic Bulk flexconnect AP changes in Wireless

Bulk flexconnect AP changes

Daniel Graham — Mon, 05 Jul 2021 06:55:46 GMT

Is there a way to make AP mode change to flexconnect / flexconnect vlan mappings to a group of AP's at the same time?

Bulk flexconnect AP changes

Rasika Nayanajith — Thu, 09 Jan 2014 18:50:05 GMT

Hi Dan,

I do not think so. (not sure any prime template can be used for this though)

Anyway you have to change AP mode to Flexconnect individually, do the VLAN mapping as additional step in that task.

HTH

Rasika

**** Pls rate all useful responses ****

Re: Bulk flexconnect AP changes

Stephen Rodriguez — Thu, 09 Jan 2014 22:35:25 GMT

There might be a template you could push from PI that will set the vlans on the AP if it's already in FlexConnect mode.

I usually just do those changes from the cli myself though.

Steve

Sent from Cisco Technical Support iPhone App

Bulk flexconnect AP changes

Saravanan Lakshmanan — Thu, 09 Jan 2014 23:10:53 GMT

in 7.5 and 7.6 have a feature where you can push vlans to flexconnect group where the flex APs were added.

http://www.cisco.com/en/US/docs/wireless/controller/7.5/config_guide/b_cg75_chapter_010001001.html#d30073e1468a1635

Re: Bulk flexconnect AP changes

Scott Fella — Fri, 10 Jan 2014 11:33:57 GMT

Just to add... You can create a cli command script to change the mode if the access point from local to FlexConnect and then change the native vlan then add the WLAN to vlan mapping. I put something out on the forums a while back to change the WLAN to vlan mapping which might help.

https://supportforums.cisco.com/thread/2221117

Sent from Cisco Technical Support iPhone App