topic Difference between AP Operational Status and Registered Controll in Wireless

Difference between AP Operational Status and Registered Controller

bischoffb — Sun, 04 Jul 2021 07:35:45 GMT

When reviewing the AP Details page in Prime there are two fields I'm not sure what they mean specifically:

1) Operational Status - Registered

2) Registered Controller - Not Associated

Any clarity or document references would be greatly appreciated.

Difference between AP Operational Status and Registered Controll

Leo Laohoo — Tue, 06 Aug 2013 11:29:57 GMT

#1 will tell you if the AP is registered to a controller or not.

#2 will tell you which controller the AP is registered to.

So it's obvious that if you have an AP that went offline, WCS/NCS/CPI will show you have "Not Associated" in #2 but has been registered some time before.

Difference between AP Operational Status and Registered Controll

bischoffb — Tue, 06 Aug 2013 11:35:14 GMT

Thanks Leo.

To get into the weeds some...is there a technical difference between "registered" vs "associated"? Were these specific terms chosen relative to 802.11 or purely Cisco choice.

What are the impacts of being registered vs but not associated?

Thanks you.

Difference between AP Operational Status and Registered Controll

Leo Laohoo — Tue, 06 Aug 2013 11:44:41 GMT

Were these specific terms chosen relative to 802.11 or purely Cisco choice.

You are seeing this behaviour when you are looking at WCS/NCS/CPI? If this is the case, then this is Cisco's "terms".

What are the impacts of being registered vs but not associated?

In the list of APs, if you get "registered" but doesn't show the controller IP address then this is because the AP is "off the air".

Difference between AP Operational Status and Registered Controll

bischoffb — Tue, 06 Aug 2013 12:40:59 GMT

This is in CPI viewing the AP Details tab.

The only valid values for Operational Status are Registered/Not Registered.

The only valid values for Registered Controller are Associated/Not Associated

The IP address is not a valid input.

It is still unclear to me what the specific and fuctional differences and impacts are between Operational Status and

Registered Controller? How do the values of each impact the client device?

Thank You.

Difference between AP Operational Status and Registered Controll

Leo Laohoo — Tue, 06 Aug 2013 21:52:47 GMT

How do the values of each impact the client device?

If you get "Registered" but doesn't have the IP address of the controller, then the AP is not working.