topic Re: Lightweight AP Template - FlexConnect Parameters error in Wireless

Lightweight AP Template - FlexConnect Parameters error

JASON SIMMONS — Sun, 04 Jul 2021 05:23:06 GMT

I created a LAP Template in NCS to configure some new 1142 LAPs that were installed in a remote office. These LAPs need to be in FlexConnect mode with VLAN support. The template is being applied with partial success on every access point. Details of the partial success say the FlexConnect Parameters fail with the following error.

Provision Failure: com.cisco.wnbu.server.common.errors.ObjectNotFoundException cannot be cast to com.cisco.wnbu.server.common.errors.InternalException

Am I doing something wrong?

The FlexConnect portion of the template has VLAN Support enabled, Native VLAN ID, and the Profile Name-VLAN Mappings configured.

Prime NCS version 1.1.1.24

Access Points are AIR-LAP1142N-A-K9s running 7.2.110.0

Re: Lightweight AP Template - FlexConnect Parameters error

Amjad Abdullah — Tue, 10 Jul 2012 18:33:40 GMT

Jason:

Is it mentioned anywhere that it is "partially" succeeded?

As i see from the message it is failed!

Sent from Cisco Technical Support iPad App

Re: Lightweight AP Template - FlexConnect Parameters error

JASON SIMMONS — Tue, 10 Jul 2012 19:04:48 GMT

Can you offer any insight as to why it failed?

Re: Lightweight AP Template - FlexConnect Parameters error

Pierre Vilander — Tue, 08 Jan 2013 06:44:38 GMT

Any updates to share in this case?

.......

Solution:

Make one template just to reconfigure the AP to Flexconnect without settings, apply and reboot. Then to make another template which do the FlexConnect settings you want to add. Can not be done with just one template...(as far as I know)

Because the FlexConnect-settings cant be applied if the AP isnt a FlexConnect already.