WCS AP template application

Mirza Cutuk — Sun, 04 Jul 2021 04:17:33 GMT

Hi, i started getting this weird error message yesterday in WCS.

I have some generic and some per location templates.

Admin status on/off, hreap enable are generic.

Then i have templates for every location, as they are on separate vlans.

Hreap template applies fine, then the AP reboots.

When i try to apply template with native and switched vlans, thats when i get the error.

Unfortunately i am qute fresh with cisco wireless, and i have difficulities finding an answer on this topic.

Recently i upgraded WCS to 7.0.220. But i have deployed like 50 aps after the upgrade too, without any problems.

Stephen Rodriguez — Fri, 23 Dec 2011 15:27:03 GMT

With the native VLAN you need one template that enables that. Then a secondary template that assigns the VLAN mappings.

Give that a try and let us know how it works.

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

topic WCS AP template application in Wireless