topic Command to find controller on AP in Wireless

Command to find controller on AP

ewood2624 — Sun, 04 Jul 2021 04:17:11 GMT

I'm trying to remember what the command is to find the controller IP on a LAP1142 running 7.0.220.0 code.

Command to find controller on AP

Stephen Rodriguez — Thu, 22 Dec 2011 15:16:26 GMT

on the AP, the command is show capwap client config. that should show you the primary/secondary/tertiary WLC the AP is assinged to.

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

Command to find controller on AP

Viten Patel — Thu, 22 Dec 2011 15:30:42 GMT

show capwap client rcb

Re: Command to find controller on AP

MarkMark58076 — Thu, 22 Aug 2019 06:05:48 GMT

i made a comparison between both AP and there is no difference.

AdminState : ADMIN_ENABLED
OperationState : UP
Name : LabAP
SwVer : 8.8.111.0
HwVer : 1.0.0.0
MwarApMgrIp : 172.16.11.5
MwarName : cisco1815i
MwarHwVer : 0.0.0.0
Location : default location
ApMode : FlexConnect
ApSubMode : Not Configured
CAPWAP Path MTU : 1485
CAPWAP UDP-Lite : Enabled
IP Prefer-mode : IPv4
AP Link DTLS Encryption : OFF
AP TCP MSS Adjust : Enabled
AP TCP MSS size : 1250
LinkAuditing : disabled
Efficient Upgrade State : Enabled
Efficient Upgrade Role : Local
Flex Group Name : default-flexgroup
AP Group Name : default-group
Cisco Trustsec Config
AP Inline Tagging Mode : Disabled
AP Sgacl Enforcement : Disabled
AP Override Status : Disabled
BLE Module Admin State : Disabled
Hyperlocation Admin State : Disabled