topic AP 521 after conversion from autonomous doesn't work in Wireless

AP 521 after conversion from autonomous doesn't work

eidoslanesi — Sun, 04 Jul 2021 00:55:24 GMT

I have buyed a WLC-526 and three AP521 AP. On the first AP521 I used the "Convert to LWAPP" tab in the configuration drawer, according Cisco procedure and after that I downloaded the c520-rcvk9w8-tar.124-10b.JX.tar image. After the procedure running, the AP521 goes in continous loop reload.

What's wrong? How can I recovery the initial image.

thanks an advance

martog

Re: AP 521 after conversion from autonomous doesn't work

dancampb — Fri, 07 Aug 2009 12:33:59 GMT

Depends on how far the bootup is going. After the AP is converted to LWAPP it will keep rebooting if it can't find a controller to join.

Re: AP 521 after conversion from autonomous doesn't work

eidoslanesi — Fri, 07 Aug 2009 12:46:10 GMT

The WLC 526 is on the same subnet as APs.

martog Thanks