topic Re: Factory Reset for AP 1010 in Wireless

Factory Reset for AP 1010

sujithr — Sun, 04 Jul 2021 00:20:56 GMT

Hi all,

One of my AP 1010 got a static IP in vlan 110 Range but Controller is in Different(default) Vlan. Due to this its not getting registerd with WLc. Anybody can suggest any procedure to remove that IP from AP.

Re: Factory Reset for AP 1010

dennischolmes — Mon, 23 Mar 2009 14:01:48 GMT

My first post didnt show up so here we go again. The 1010 has a 2 pin console port inside of it to do a lwapp config to default factory reset. You open it up with a terminal session. This requires a special cable as well. The easiest way will be to get a spare controller and set the interfaces to be on the same network as the AP. Once it joins, reset the AP to factory defaults and reboot it. Make sure it comes back up then simply change it from static to dhcp and join it to the new network and controller via dhcp. Make sure all versions of code support the 1000 series APs.

Re: Factory Reset for AP 1010

sujithr — Wed, 25 Mar 2009 06:33:42 GMT

Could you please let me know the type of cable should be used to get the access.?

Re: Factory Reset for AP 1010

dennischolmes — Wed, 25 Mar 2009 14:59:56 GMT

I got mine from Airespace and have no clues as to which pins were pinned out on it. I haven't seen it in 2 years or I would open it up and look. It is a serial 9 pin to a small 2 pin connector.