topic Re: AP VLAN/Bridging Support in Wireless

AP VLAN/Bridging Support

darkmagex — Sat, 03 Jul 2021 23:15:13 GMT

I need to bridge a network segment with 2 VLANS across a medium range wireless link. Currently we have 1231Gs which can do this, however they seem to only support one VLAN in WGB mode.

Is there any configuration in which the 1231G supports multiple VLANs over a bridged link? If not would the 1240 series be our best bet?

Re: AP VLAN/Bridging Support

bcolvin — Thu, 31 Jul 2008 05:41:23 GMT

Jeff

Sounds like you have an old IOS version the current versions support Root and Non-Root bridge roles, and will run mutiple SSID's and VLANs.

Use the GUI for configuration and you will do fine.

HTH

Bill

Re: AP VLAN/Bridging Support

bsuhelpdesk — Fri, 01 Aug 2008 02:41:26 GMT

Is it possible to do this with a 1010AG-LWAPP or 1130AG-LWAPP as ROOT and Fat 1130AG on the NON-Root. Thanks!

Re: AP VLAN/Bridging Support

darkmagex — Fri, 01 Aug 2008 12:19:52 GMT

Thanks for the information, does the 1230 support the same configuration or is it limited by it's RAM?

Re: AP VLAN/Bridging Support

bcolvin — Sat, 02 Aug 2008 00:59:21 GMT

As far as I know it will work on all 123x AP's, the real test is if you load the current version or at least 12.3 (8). If the option for the Root or Non Root role is available in the radio configuration it should work.

Good luck

Bill

Re: AP VLAN/Bridging Support

bcolvin — Sat, 02 Aug 2008 01:01:48 GMT

It is probably dooable but the 1010 and 1130 AP's are designed for use in an office environment and may not survive the environmental extreams found in typical bridge installations.

Bill